HVAC load calculator

Manual J load calculator for Arizona homes

Estimate the cooling capacity your house actually needs before you shop for a replacement system. Built for Phoenix, Tucson, Yuma, Prescott and Flagstaff design conditions.

Estimated cooling capacity

5.5 tons

61,330 BTU/hr · about 2,200 CFM of airflow

Rounded up to the next half ton. A room-by-room Manual J often lands a little lower, so confirm before you buy.

Where the load comes from

  • Walls, roof and floor49,280 BTU
  • Windows (10 × double pane, clear)7,500 BTU
  • People800 BTU
  • Appliances and lighting3,750 BTU

How the estimate is calculated

  • Envelope load: conditioned square footage is multiplied by the design load for your climate zone, then adjusted for ceiling height and attic insulation.
  • Window load: each window adds heat gain based on glass type. Single pane glass in an Arizona afternoon sun adds about twice the load of low-E glass.
  • Internal load: people and appliances add to the total, then the result is rounded up to the next half ton so the equipment is not undersized.

Next step: size the ducts

Once you know the tonnage, run the number through the duct size calculator to check trunk and branch sizing. A correctly sized air conditioner still underperforms on an undersized duct system.

Common questions

How many tons of AC do I need for 2,000 square feet in Phoenix?

Most 2,000 square foot Phoenix homes land between 4 and 4.5 tons once windows, insulation and appliance load are counted. That is roughly one ton per 450 to 500 square feet, but ceiling height and window glass move the number a lot.

Is this the same as a Manual J calculation?

No. This is a whole-house estimate built from square footage and typical Arizona design conditions. A Manual J in Manual J software measures every room, window orientation, duct run and construction assembly, and that is what equipment sizing and permits are based on.

Why does oversizing matter in Arizona?

An oversized system cools the house too fast, shuts off before it removes humidity, and cycles its compressor harder. In a dry climate the short cycling also means uneven room temperatures and a shorter equipment life.

What airflow goes with the tonnage?

Plan on 400 CFM per ton. A 4 ton system needs about 1,600 CFM through the air handler and the trunk duct. Undersized return air is the most common reason a new system underperforms.

Need a stamped room-by-room Manual J?

We run the full calculation, check your duct static pressure and quote the right size the first time.

Call (480) 316-8620

JAMRAC Mechanical LLC · Licensed HVAC and electrical contractor serving the Phoenix metro area.

These calculators give a planning estimate for Arizona homes. Equipment selection still needs a room-by-room load calculation and a permit-ready design.

© 2026 JAMRAC Mechanical LLC. All rights reserved. Terms of Use

Do not copy any part of this app. Do not use the app for any other purpose.